Z-Truck Assembly with CarveTight Spindle

Upgrade your CarveWright with the CarveTight Spindle System for a machine that runs quieter, smoother, with less run-out, vibration and heat build-up.
The CarveTight Spindle System is easy enough to install yourself!

Includes:

• • CarveTight Spindle installed in z-truck

• • 2 adjustable roller bearings

• • 2 screws

• • 2 washers

• • 1 Cam roller wrench

• • 1 4mm T handle allen wrench

DOES NOT INCLUDE NECESSARY BITS, COLLETS, COLLARS AND ADAPTERS. THESE MUST BE ORDERED SEPERATELY.

See the installation video on the CarveTight page here or use installation PDF below.

VERY IMPORTANT:  Your machine must already have the A907 upgrade before you install the new CarveTight Spindle.  Not sure if your machine needs it? Only some “A” model machines would require this.  Check HERE.

• • Carbide bits (1/16″ Carving & 1/8″ Cutting) will need to be replaced with ones that have the HARD PRESSED adapter. QC bits cannot be successfully retro-fitted.

• • If you own the Full Bit Set, you need to also purchase the 1/4″ Split Collet (P005-00053), the 1/4″ Rubber Stop Collars (A005-00054) and 1/2″ Rubber Stop Collars (A005-00055).

• • If you own the Scanning Probe, you need to also purchase the Scanning Probe adapter (P005-00052).

• • CarveTight users may also want to purchase these bits that can be used in their new spindle – 1/8″ carving (soft materials only), 3/16″ carving & 3/16″ cutting bits, which come only with the hardpressed adapters

• • Updating your Designer software to a newer version may be necessary

Want to have us upgrade your machine?  Call 713-473-6572 for pricing.